Husqvarna Concrete Finishing Equipment

The Husqvarna CT 36 walk-behind trowels feature a trowel diameter of 36 inches and are ideal for finishing medium-sized areas. The trowels are optimally balanced, therefore they can be effortlessly controlled in the wide range of speeds. The transmission brake, electronic safety switch and engine speed sensor offer additional triple protection for the user. In an emergency situation the device will simply switch off and the handle will come to a stand-still after no more than a three-quarter turn. Furthermore, the unit will only start if the throttle lever is set to zero. This prevents an inadvertent rotation of the handle on start-up.

Motor/engine model GX160
Output power (As rated by the engine/motor manufacturer) 3.6 kW
Power output 3.6 kW
Fuel tank volume 3.1 l

The Husqvarna CT 48 walk-behind trowels with a diameter of 122 cm are ideal for finishing medium-large areas. The trowels are optimally balanced, therefore they can be effortlessly controlled in the wide range of speeds. The transmission brake, electronic safety switch and engine speed sensor offer additional triple protection for the user. In an emergency situation the device will simply switch off and the handle will come to a stand-still after no more than a three-quarter turn. Furthermore, the unit will only start if the throttle lever is set to zero. This prevents an inadvertent rotation of the handle on start-up.

Motor/engine model GX240
Output power (As rated by the engine/motor manufacturer) 5.9 kW
Power output 5.9 kW
Fuel tank volume 5.3 l

The Husqvarna CRT 36, 36-inch, ride-on trowel offers high quality results, productivity and operator comfort. One person can easily raise and lower the integrated wheel set from one jack at the rear of machine allowing easy manoeuvrability around the job site. During use, the wheel kit does not block the operator’s line of sight. CRT 36 is ideal to finish surfaces from 3,000 sq ft up to 10,000 sq ft. Thanks to the CVT clutch, CRT 36 can be used at low engine speed with pans for the first passes to reach a high level of floor flatness, and can be used also with finishing blades at higher engine speed to burnish the concrete.

Motor/engine model GX690
Power output 16.5 kW
Fuel tank volume 24.6 l
Vibration value, m/s² 1.8

The ride-on trowel Husqvarna CRT 48 PS with power steering achieves high productivity with excellent results thanks to its optimal maneuverability and high surface capacity as well as a balanced power-to-weight ratio. CRT 48 PS is ideal to finish surfaces from 10,000 sq ft up to 25,000 sq ft. The electro-hydraulic joystick control enables accurate maneuvering and virtually fatigue-free operation. Controlled by joystick modulations, the valves of the hydraulic control cylinder are triggered by electrical signals. CRT 48 PS offers a choice of two control modes to accommodate operator preference in varying site conditions.

Motor/engine model EFI-37HP
Power output 27.6 kW
Fuel tank volume 24.6 l
Vibration value, m/s² 2.2